I have to carry out a Local Seismic Response study and am unable, after numerous attempts, to export accelerograms with the Rexel software. I have seen that some online portals provide the possibility of exporting accelerograms but only for a period. I then verified that there is the INGV portal (REXELWEB) from which it is possible to export accelerograms. The problem is that in the latter case I am able, for the site I am interested in, to export the accelerograms, but the doubt is related to the conversion factor of the RSLIII programme: I have guessed that it must be 0.01 instead of 100 which is the default when the ‘single step accelerogram column’ tick is selected? Could you give me some indication of this, since I can find no indication from what I have downloaded from RexelWeb?

The conversion factor depends solely on the unit of measurement in which the acceleration data is reported and the unit of measurement in which you have chosen to work with RSL III software (in g or in m/s2). If, for example, you have chosen to work in [g] and the accelerogram is in [m/s2] then…

Installation and usage tutorials

https://www.youtube.com/watch?v=pA5zBsPSMLE Once Autocad is open, go to Tools>Macro>Load Project; Choose the project file to be imported into Autocad; Confirm the file is loaded by clicking on ‘Load’; Click on ‘Enable Macro’; Go back to Tools >Macro Select the macro that adds the menu: end of the name ‘!Manage_menu.add_menu’ and click ‘RUN’; The menu item ‘Geostru’…

When starting the software I get the message: ‘Class not registered. The following file must be installed on the computer. MSSTDFMT.DLL

You need to check whether the msstdfmt.dll file is located in the folder c:\windows\system32 or c:\windows\syswow64. If it is present, after performing the above check you must start the DOS Prompt or CMD as administrator. In the DOS Prompt write regsvr32 c:\windows\system32\msstdfmt.dll (if the msstdfmt.dll file is located in the c:\windows\system32 folder) or regsvr32 c:\windows\syswow64\msstdfmt.dll…

After downloading the setup.exe, I get the error message ‘The administrator has blocked the application because it poses a serious security risk to the computer’.

Causes: The Windows ClickOnce reliability request message is disabled. ClickOnce, a component of the .NET Framework, must be enabled to run Slope Solution: To fix the problem, enable this registry key: HKLM\SOFTWARE\MICROSOFT\.NETFramework\Security\TrustManager \PromptingLevel\Inte promrnet Note: This operation must be performed by an administrator with technical knowledge of the Windows Registry. To activate the registry key…

Did the administrator block this application because it could pose a security risk to the computer during the installation?

Causes: The Windows ClickOnce reliability request message is disabled. ClickOnce, a component of the .NET Framework, must be enabled to run Slope Solution: To fix the problem, enable this registry key: HKLM\SOFTWARE\MICROSOFT\.NETFramework\Security\TrustManager \PromptingLevel\Inte promrnet Note: This operation must be performed by an administrator with technical knowledge of the Windows Registry. To activate the registry key…